Motor Rated FLA External Fault The multi-function input terminals can be used to define various modes of external faults. Integral Time Factory setting: The staff was friendly and knowledgeable and we will definitely order from them in the future. Maximum Output Frequency Maximum Voltage. If it is unavailable, use the following formula to calculate it: The pulses can be checked after they have been processed by the PG-X2 card or at the motor.

Uploader: Faulkis
Date Added: 13 January 2005
File Size: 63.25 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 27782
Price: Free* [*Free Regsitration Required]

Increase acceleration time C Run command is disabled Selection during program mode During 1: Do not use both of these power supplies simultaneously. Digital Operator Menu Trees Email to friends Share on Facebook – opens in a new window or tab Share on Twitter – opens in a new window or tab Share on Pinterest – opens in a new window or tab.

The following explains the outline of the methods. The drive also retains the operating conditions when the fault occurred. Increase torque limit values Lif they are reduced from factory settings.

Choosing this option will allow only those parameters programmed in A 2 – X X to be accessed in “Programming”. If the motor cannot be disconnected from the load, or if Auto-Tuning fails, motor parameters should be entered manually. The factory setting is ” 1.


EMS Yaskawa G5 Magnetek GPD 515

The accel time C 1 – 0 1 is set too short relative to the load if the RPM of the accelerating motor does not increase smoothly, or if a fault is displayed on the Digital Operator. When an external Jog signal is present, it will override the existing operation mode and the drive will ramp to the level set by this parameter.

Dwell Frequency at Magndtek Factory setting: Add to watch list. Voltage is preset to V at the factory. Table lists the possible data setting values for these parameters, with the function and a brief description for each one.

Yaskawa GPD /g5 Model Cimr-g5m25p5 Gpdc-a 25p51f MAGNETEK G5 | eBay

Factory setting differs depending on the drive capacity. A A thru A 1 b b b 1 1 0 5.

Mount the Braking Transistor Unit s on a vertical surface. The DC injection voltage is determined by the DC injection braking gdp-515 and motor impedance.

H H H H H H These six parameters select the input signal functions for terminals 3 thru 8, and can be independently set.

Price also come with a very quick delivery with exactly as ordered. During acceleration, if the output current exceeds the value in Magetek 3 – 0 2acceleration stops and frequency is maintained.


Multi-function Analog Input 2 Selection Term. For parts or not working Price: If the motor being used with the drive did not pass magnetk auto-tuning or if the motor cannot be disconnected from the load, the motor parameters need to be calculated and entered manually.

When o 2 – 0 3 is not set to ” 1 “, this option is not available.

G5 GPD515 Drive

For constant horsepower applications, set to maximum frequency desired. Fast Stop Selection 3: Please enter a number less than or equal to 1.

For further details on dynamic braking operation, see the instruction sheet shipped magnerek dynamic braking components. Zach Snipes was very helpful in getting me what I needed. The figures following the chart show how each setting configures the analog input. Coast to Stop Detection 2: The DC bus voltage level is monitored, and the deceleration rate is automatically extended to prevent an overvoltage condition. Gpc-515 Model was delivered in good condition and installed at the unit.