Jun 4, at 7: This is an easily implemented and excellent idea. Printers that are asleep? Would be nice to eliminate that error message though. After it gives the driver didn’t load error, just right click the ET6 icon in taskbar and select show and easytune opens. Sorry this didn’t help.

Uploader: Vigar
Date Added: 19 March 2006
File Size: 51.80 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 97145
Price: Free* [*Free Regsitration Required]

Welcome to Microsoft Community and thank you for your interest in Windows Thanks for marking this as the answer.

I upgraded my second computer, a desktop, to Windows 7 recently and devicf trying to set up home network. I uninstalled all the Microsoft installed devices i. If the problem persist, try the following: Then they blamed the problem on third party programs that might be installed on the system there were none, just the latest mot for every hardware component. LSD, I do not have.

Vidojko Created on June 16, It takes a few seconds to attempt to start and then gives an error message about an incorrect driver. I find it hard to believe that this problem has not been addressed. Sounds strange, but should work.


Devices and Printers does not load

Jun 2, at 8: Note that you may need to have your Windows disk fould hand to re-install it. Tech support scams are an industry-wide issue where scammers attempt to trick you into paying for unnecessary technical support services. I would suggest you to run Printer troubleshooter to diagnose the exact issue. The printer isn’t the problem.

Insert the Windows 7 DVD devicf. In connection with some overclocking through the biosLSD asked me to use ET6 to check some actual voltages.

Ephebus, I am on my third Gigabyte board. Post a image of it if you like.

Jun 6, at 7: In reply to Billion Fevice post on September 17, Here is a screen clip where I waited over 5 minutes without it occurring. The system fails and said to wait or close program.

easy tune 6 gui error

A clean install would be much easier than trying to narrow down what driver or program is causing this, or whatever else the problem might be. Well UD7 is so new I am not sure if it is working for this board yet, I will ask around and see what I can find. I’m just lowd, because I’m trying to overclock my i7 to 4 GHz.


Now only the graphics tab isn’t accessible. See if that changes the way Devices and Printers starts up.

This Driver can’t release to failure in Windows 10 [SOLVED] – Driver Easy

I’m using win 7 64 bit and haven’t experience any problem, well when I double click the ET6 it will won’t load up as the usual application but you can see xevice the list of running in the background on the task bar the ET6 icon right click on that and then select show up Sign up using Facebook. I assumed it is now incorporated into Windows 7. It’s almost certainly a motherboard and or BIOS issue. Most people should be able to memorize a lot of BIOS settings cold.

There are reports of success going both ways. I hope that “Easy Tune 6” problem will find solution soon.